Forums » Support

Back To Topics

How do I create a sequential program?

  • January 17, 2019 4:35 AM CET

    Basically, I just need a couple of motors to complete a set of start/stops on a timer, via the push of a button

    What you see below are two channels controlling each motor. I know there's an error in the "knifes" sequence, but I can't be bothered redo it and screenshot it again. Anyway, look at the graph above. Am I on the right track or completely off? When I tap the pink button in the app, the "bale turner" motor runs very slowly, the longer I hold the button the faster it goes. Similarly, when it's at 100% and I hold the button, it slows down gradually to 0 and then nothing.

    How do I do it?

    This post was edited by Carsten Svendsen at January 17, 2019 6:19 AM CET