Forums » Support

Back To Topics

Seeting a control for a train

    • 315 posts
    April 14, 2021 3:18 PM CEST

    Hi,

     

    You can set the slider to autoreset off in the Profile Designer, so the slider will not go to zero if you release.

    For button stop/start you can create sequence for slow-start and for slow-stop and you can fire the sequence with the circuits function.

    • 2 posts
    March 31, 2021 10:31 PM CEST

    Hello, I've tried using sliders, but I only chas been able to activated thew tain when I push the sliders, if I stop pushing the slider the train stop, and it dont go in reverse if I push the opossite slider

    What I would like to do is  touse the button to start the train, and go increasing speed (up and down) clicking the button, the same for make the train going in reverse. It's that posible?


    This post was edited by Javsos at March 31, 2021 10:33 PM CEST
    • 315 posts
    March 30, 2021 12:54 PM CEST

    Hi,

     

    What type of controls are you using?

    Sliders, or buttons?

    You can use sequences with buttons if you want to slow start/stop.

    • 2 posts
    March 27, 2021 6:41 AM CET

    Hello, someone has set up a remote control for a Train? I can't make the motor going in reverse, neither increase or reduce the speed by steps (as in the official Lego Control Remote). Could somebody provide some advice to me?


    This post was edited by Javsos at March 27, 2021 6:42 AM CET