Updates

• 
  Sven Püttmann posted a topic in the forum Support:

  Question about SBrick

  Hi all,
   
  I'm very new to the community and just received my very first sbrick. I planned to use it in a simple Lego technic Moc, just with an L-Engine and a Servo.
  I'm using the IOS app. The SBrick has hardware version 13, firmware 25. The LED...  moreHi all,
   
  I'm very new to the community and just received my very first sbrick. I planned to use it in a simple Lego technic Moc, just with an L-Engine and a Servo.
  I'm using the IOS app. The SBrick has hardware version 13, firmware 25. The LED tester works, I can also see some activities on each port when I check the port configuration with an connected engine.
  Then I did a creation, downloaded a profile  (tested with Lego 9938 and Lego 43037s), and connect the engine and the servo with the ports and setup this in the controller profile. 
  Now the problem: 
  When I run a test if the connected engine works on the selected port, nothing happens. Same when I save the setup and run the test or also when I run the steering ui, nothing happens at all.
  Does anybody know the behavior? Is there still smth wrong in the setup?
  Thanks in advance for your answers!
   
  BRSven  less

  • May 31, 2020