[blockquote]Rogier Landman said:
I have a car that I am steering with a slider but it's not centered. Is there a way I can calibrate (center it and set limits the movement extent)?
[/blockquote]
Hi! I had the same problem. Your steering motor has a centered position. You just have to remove the gear wheel, center car wheels, power motor (it will center itself) and return back gear.
[blockquote]Rogier Landman said:
I have a car that I am steering with a slider but it's not centered. Is there a way I can calibrate (center it and set limits the movement extent)?
[/blockquote]
Dear Rogier,
If you set the "Start" point to 0,5 in the Profile Designer, the starting point will be in the center. (You can do this after added a slider to your profile.)
To set the movement extent, the easiest way is to switch the minimum and maximum value of the sliders.
The basic options are for minimum -1, and maximum +1. If you set these values lower the movement extent will be reduced.
For example you set 0.75 to maximum and -0.75 to minimum. Your creations movement extent will be lower in this case.
I hope this will help, if you need any further help please contact us via e-mail. You can find us at info@sbrick.com
Best regards,
Balint
SBrick Team