Updates

• 
  Stuart Roll replied to a topic in the forum Support:

  I am one of the people suffering the all-zeros-for-device-info and slider-goes-to-1-and-motor-stops issues.  I see that there is a new release as of October 22 (version 4.0.3).  Are the recent posts regarding the app crashes installing this...  moreI am one of the people suffering the all-zeros-for-device-info and slider-goes-to-1-and-motor-stops issues.  I see that there is a new release as of October 22 (version 4.0.3).  Are the recent posts regarding the app crashes installing this latest version?  If so, I will hold off on the update for a while (despite Allan Clausen's encouraging post).  

  • October 24, 2016
• 
  Stuart Roll replied to a topic in the forum Support:

  Samuel Li said: Luis Flores said: I have a different problem besides the update erased all the configurations I have. My sbrick works as expected until I slide my finger to the top of the slider, in this position the motor stops. This happens with any...  moreSamuel Li said: Luis Flores said: I have a different problem besides the update erased all the configurations I have. My sbrick works as expected until I slide my finger to the top of the slider, in this position the motor stops. This happens with any control, any profile, any creation. This leaves the sbrick useless. I have an iPhone 6S with the last iOS update. I have the exact same problem after updating the iOS app. Motor stops when I move a slider to the very end of either direction. I tried to update the firmware. The app shows that my Sbrick temperature is 0, voltage is 0, hardware version is 0 and firmware version is also 0. When I click the "update firmware" button, it says "This Sbrick has got the newest version of the firmware.". I have tried this on iPhone 5s and iPad Air 2 and both have the same problem, even after rebooting the devices. Both devices are running iOS 9.3.2. Any help would be greatly appreciated. Thanks.  
  I too, have been suffering from the same symptoms for quite a...    less

  • September 17, 2016
• 
  Stuart Roll has just signed up. Say hello!

  • October 21, 2015